F-2025 Drawn cup full complement needle roller bearings 20x26x25mm

Drawn Cup Full Complement Needle Roller Bearing F-2025

Demension: 20×26×25mm ,    Weight: 33g.

SHAPE LOCATION TOLERANCE SHOULD BE TO CURRENT STANDARD;

Outer ring for drawn cup needle roller bearings(DC type) is made of cold rolled steel strip accurately formed.Structure of DC needle roller bearings features space saving and higher capacity.They are suitable for applications with limited space and housing not hard enough to act as raceway. No requirement on axial location when the DC needle roller bearing is pressed into the housing.

Drawn Cup Full Complement Needle Roller Bearing F-2025

In most applications inner ring is not necessary for DC needle roller bearings unless shaft raceway is impractical,standard inner rings for DC to compare with open end DC needle roller bearings, close end DC needle roller bearings are good for sealing at the close end of bearings,operating temperature range for bearings grease lubricatedare 20℃ to +120℃.

1.This kind bearing consists of full of needles extending to outer raceway, thus bearing high load. It is applied

to the situation where the devices mounted with needle roller bearings run in swinging operation with low and

middle speed. Since the bearings are fed with lubricating grease when are delivered, it is unnecessary to add

the lubricating grease in assembling.

Model F, FH open-end drawn cup needle roller bearing with full of needles,

Model MF, MFH hole-sealed drawn cup needle roller bearing with full of needles,

Model FY open-end drawn cup needle roller bearing with full of flat-head needles,

Model MFY close-end drawn cup needle roller bearing with full of flat-head needles

2. Inspection the enveloping circle diameter
    The dimensional accuracy of drawn cup needle roller bearings cannot be measured before fitting
    without a ring gauge as the thin-walled outer ring can be out of round due to the manufacturing process.
    The bearings obtain the accuracy required for their correct function only when pressed into ahousing
     bore which must be manufactured with the recommended tolerance limits.
     The enveloping circle diameter can then be checked as follows:
a.   Press the bearing into a steel ring gauge(wall thickness≥20mm).The bore dimension of the ring
        gauge must correspond to that given.
b.   Measure the enveloping circle diameter with cylindrical go and no-go gauge plugs. 

This kind bearing consists of full of needles extending to outer raceway, thus bearing high load. It is applied

to the situation where the devices mounted with needle roller bearings run in swinging operation with low and

middle speed. Since the bearings are fed with lubricating grease when are delivered, it is unnecessary to add

the lubricating grease in assembling.

Model F, FH open-end drawn cup needle roller bearing with full of needles,

Model MF, MFH hole-sealed drawn cup needle roller bearing with full of needles,

Model FY open-end drawn cup needle roller bearing with full of flat-head needles,

Model MFY close-end drawn cup needle roller bearing with full of flat-head needles

Drawn Cup Full Complement Needle Roller Bearing F-2025